Mikster DLM-080 Instrukcja Użytkownika Pobierz pdf (Strona 13)

The DLM-080 FUTURE Digital Recorder – User’s Manual

26.11.2004

time-meter will be reset to zero and as soon as Tini contact closes the count down

will be repeated, if the time-meter does not reach the set value and Tini contact

will open, time count down will stop and as soon as Tini contact closes the count

down will be further repeated

• F62-F69 = 2 then - if Tini contact closed, time-meter counts down until reaching

the set value – each opening of the Tini contact will result in resetting the time-

meter to zero and as soon as Tini contact closes again, the count down will go on

ATTENTION: Reaction to change of Tini contact state takes approximately 3 seconds !

In order to connect Tini contact follow the procedure described on the DLM-080 back panel!

In order to ensure correct work of the channel as time-meter, the To(n) value

saved in the F14 – F21 cells and referring to work of the channel as a multivibrator

must be equal.

4.4 CHANNEL AS MULTIVIBRATOR

The DLM-080 enables to declare relay output as a multivibrator operating according to

the algorithm shown below.

Zał

Wył

Zał

Wył

Prog(n)

Re(n)

Tz(n)

To( n )

where:

• n – channel number

• PROG(n) – state of diode in the PROG key for channel n

• RE(n) – state of relay for channel n

• tz(n) – preset time for channel n

• To(n) – multivibrator period for channel n given in the F14-F21 SETUP functions

•

τ - time in compliance with definition in the F14-F21 SETUP functions

Press and hold the key for approximately 3 sec. to reset time-meter and start the

time count-down process (diode built-in in the key is on). Press the key in order

to stop time count-down. Press the key to restart channel operation as a

multivibrator.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Brak uwag

Mikster DLM-080 Instrukcja Użytkownika Strona 13